BPT MANUFACTURING COMPANY -- SHINE-ON FLOOR FINISH, 527 -- 7930-00N084777
===================== Product Identification ===================== Product ID:SHINE-ON FLOOR FINISH, 527 MSDS Date:12/21/1988 FSC:7930 NIIN:00N084777 === Responsible Party === Company Name:BPT MANUFACTURING COMPANY Address:9758 RUSSELL AVENUE City:GAITHERSBURG State:MD ZIP:20879-3276 Country:US Info Phone Num:301-417-0442 Emergency Phone Num:800-522-3556 CAGE:053H7 === Contractor Identification === Company Name:B.P.T. MANUFACTURING CO Address:975-B RUSSELL AVE Box:City:GAITHERSBURG State:MD ZIP:20879 Country:US Phone:301-417-0442 CAGE:053H7 ============= Composition/Information on Ingredients ============= Ingred Name:NON-HAZARDOUS INGREDIENTS Fraction by Wt: 100% OSHA PEL:N/K ACGIH TLV:N/K ===================== Hazards Identification ===================== LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER. Routes of Entry: Inhalation:NO Skin:YES Ingestion:YES Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO Health Hazards Acute and Chronic:ACUTE: EFFECTS OF OVEREXPOSURE: EYE CONTACT: SLIGHT IRRITANT. SKIN CONTACT: PROLONGED EXPOSURE MAY CAUSE DRYING OF SKIN. INHALATION: NOT CONSIDERED A HAZARD. INGESTION: SINGLE DOSE INGESTIONS ARE NOT CONSIDERED HAZARDOUS. EXTREMELY LARGE DOSES COULD CAUSE INJURY. Explanation of Carcinogenicity:NOT RELEVANT Effects of Overexposure:SEE HEALTH HAZARDS. Medical Cond Aggravated by Exposure:EXISTING CONDITIONS OF DERMATITIS MAY BE AGGRAVATED BY CONTACT. ======================= First Aid Measures ======================= First Aid:EYE CONT: FLUSH W/COPIOUS AMTS OF WATER FOR AT LST 15 MINS WHILE KEEPING EYELIDS APART. IF IRRIT PERSISTS, CONT PHYS. SKIN CONT: WASH OFF W/WATER & THEN WASH AREA W/SOAP & WATER. INHAL: IF PATIENT COM PLAINS OF HDCHE DIZZ/NAUS, REMOVE TO FRESH AIR UNTIL RECOVERY. CONT PHYS IF IRRIT PERSISTS. INGEST: INDUCE VOMIT BY GIVING IPECAC/STICKING FINGER TO BACK OF THROAT. CONT PHYS. NEVER GIVE (SUPDAT) ===================== Fire Fighting Measures ===================== Flash Point:NON-FLAMMABLE Extinguishing Media:FOAM, CO*2, WATER FOG. Fire Fighting Procedures:USE NIOSH APPROVED SCBA AND FULL PROTECTIVE EQUIPMENT . COOL FIRE EXPOSED CONTAINERS WITH A WATER SPRAY TO PREVENT BURSTING OF CONTAINERS. Unusual Fire/Explosion Hazard:RELEASE OF MATERIAL MAY RESULT IN SLIPPERY CONDITIONS. ================== Accidental Release Measures ================== Spill Release Procedures:DIKE AREA TO CONTAIN MATERIAL. AREA MAY BECOME SLIPPERY. ABSORB PRODUCT ONTO POROUS MATERIAL SUCH AS SAND, DIATOMACEOUS EARTH OR COMMERCIAL ABSORBANT MATERIAL. SHOVEL UP INTO DRUMS. Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER. ====================== Handling and Storage ====================== Handling and Storage Precautions:DO NOT STORE IN SUBFREEZING TEMPERATURES OR EXTREME CONDITIONS OF HEAT. Other Precautions:DO NOT MIX WITH OTHER CHEMICALS. ============= Exposure Controls/Personal Protection ============= Respiratory Protection:NONE REQUIRED DURING NORMAL USE OF PRODUCT. USE NIOSH APPROVED RESPIRATOR APPROPRIATE FOR EXPOSURE OF CONCERN . Ventilation:NORMAL GOOD VENTILATION IS SUFFICIENT. IN CONFINED AREAS, MECHANICAL DEVICES ARE RECOMMENDED. Protective Gloves:RUBBER OR VINYL GLOVES. Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES . Other Protective Equipment:NONE. ANSI APPROVED EYE WASH & DELUGE SHOWER . Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER. Supplemental Safety and Health FIRST AID: ANYTHING BY MOUTH TO AN UNCONSCIOUS PERSON. ================== Physical/Chemical Properties ================== Boiling Pt:B.P. Text:200F,93C Vapor Pres:27 Vapor Density:HVR/AIR Spec Gravity:1.033 pH:8-9 Evaporation Rate & Reference:SLOWER THAN WATER Solubility in Water:NOT KNOWN Appearance and Odor:MILKY WHITE EMULSION, MILD ODOR. Percent Volatiles by Volume:80 ================= Stability and Reactivity Data ================= Stability Indicator/Materials to Avoid:YES ACIDS, STRONG ALKALIS AND OXIDANTS. Stability Condition to Avoid:AVOID FREEZING OR CONDITIONS OF EXTREME HEAT. Hazardous Decomposition Products:NORMAL PRODUCTS OF COMBUSTION-CARBON DIOXIDE AND CARBON MONOXIDE. ==================== Disposal Considerations ==================== Waste Disposal Methods:INCINERATE OR LANDFILL IN ACCORDANCE WITH LOCAL, STATE OR FEDERAL REGULATIONS. Disclaimer (provided with this information by the compiling agencies): This information is formulated for use by elements of the Department of Defense. The United States of America in no manner whatsoever, expressly or implied, warrants this information to be accurate and disclaims all liability for its use. Any person utilizing this document should seek competent professional advice to verify and assume responsibility for the suitability of this information to their particular situation.